ResMed Sullivan Comfort Manuel d'utilisateur télécharger pdf (Page 19)

Section 9: Cleaning and maintenance

Remove air filter box at

rear of flow generator

Periodically

All items of the mask and air tubing system are subject to normal wear and tear

and may eventually need to be replaced. Check periodically for excessive wear in

these items.

1 When dirty, remove the headgear and wash it in warm water using a mild

detergent (about every two weeks). Rinse thoroughly and drip dry. Do not

use bleach.

2 Replace the forehead pads if they are dirty or worn (every three to six

months).

3 Clean the exterior of the flow generator when necessary with a damp cloth,

using a mild detergent. Make sure the flow generator is unplugged before

cleaning, and make sure it is dry before plugging in again.

Replacing the air filter

4 The air filter box at the rear of the

flow generator contains two replace-

able air filter strips. Check the air

filter strips periodically and replace

them when they become noticeably

dirty (about every six months, or

more often if your unit is in a dusty

environment).

To remove the air filter box:

• press down firmly on the

center of the filter box between

the two moulded arrows,

• slide out the box.

Detailed instructions supplied with the new filter strips describe how to

disassemble the filter and replace the strips.

CAUTION:  Do not immerse the unit or power cord in water as serious

damage could result.

 Do not use bleach, alcohol-based or chlorine-based

solutions to clean the flow generator, nasal cushion, mask

or air tubing. These solutions may cause hardening and

reduce the life of the products.

 Do not wash or dry the mask frame in a temperature

above 80°C (175°F). Exposure to higher temperatures

may reduce the life of the product.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Pas de commentaire

ResMed Sullivan Comfort Manuel d'utilisateur Page 19