ResMed HumidAire 3i Manuel d'utilisateur télécharger pdf (Page 15)

HAT IF I STILL HAVE SYMPTOMS OF DRYNESS?

If you still experience symptoms of dryness, then your humidity setting may be set too

low to be effective. Gradually turn the humidity control dial up over a few nights until

the symptoms disappear.

If you are still experiencing symptoms of dryness, even after increasing the humidity

setting, you may be breathing through your mouth. Mouth breathing or mouth leaks

cause drying and irritation of the upper airway. If this is a problem, a full face mask or

chin strap may help. Consult your clinician or equipment supplier for details.

CLEANING AND MAINTENANCE

You should regularly carry out the cleaning and maintenance of the water chamber,

cover and cover seal as described in this section.

DISASSEMBLING YOUR HUMIDAIRE 3i

Please refer to the illustrations in section H of the illustration sheet.

WARNING

Beware of electrocution. Do not immerse your flow generator, docking station or

power cord in water. Always unplug the device before cleaning and be sure that it

is dry before plugging it back in.

1 Unplug the power cord from the power outlet (H-1).

WARNING

Take care when handling your HumidAire 3i. The water and the water chamber

base may both be hot. Allow ten minutes for the heater plate and any excess water

to cool (H-2).

Remove the water chamber from the docking station (H-3) and discard any excess

water (H-4).

Detach the air tubing from the air outlet (H-5).

Gently flex one cover arm away and up from the docking station until the cover

detaches completely (H-6 to H-8). Peel the cover seal away from the cover (H-9).

CAUTION

Do not remove the tub plate from the water chamber.

338282r3.book Page 10 Friday, November 10, 2006 2:10 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 90 91

Pas de commentaire

ResMed HumidAire 3i Manuel d'utilisateur Page 15