ResMed VPAP III ST-A Manuel d'utilisateur télécharger pdf (Page 15)

7Setting up the VPAP III ST-A System

Setting up the VPAP III ST-A System

Please refer to the illustrations in section D of the illustration sheet.

Setting up the VPAP III ST-A

1 Place the VPAP III ST-A on a flat surface near the head of your bed. If the device

is placed on the floor, ensure that the area is free from dust and clear of bedding,

clothes or any other objects that could block the air inlet.

CAUTION

Be careful not to place the device where it can be bumped or where

someone is likely to trip over the power cord.

Connect the power cord

There are two sockets at the rear of the flow generator—the top one for an AC

(standard mains electricity) and the lower one for a DC power cord (see “Using

a Battery to Power the VPAP III ST-A” on page 33).

ResMed recommends using the AC power cord supplied with the unit.

If the customized ResMed power cord is supplied, it can be held in place with

the locking clips. To insert the locking clip, pinch the free ends together and fit

the pins into the holes on both sides of the socket. Insert the power cord into the

socket. Push the locking clip down so that the groove holds the power cord in

place.

Plug the free end of the power cord into a power outlet (D-1).

CAUTION

Do not connect both AC and DC power cords to the VPAP III ST-A at the

same time.

Power switch

AC locking clip

AC power cord

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Pas de commentaire

ResMed VPAP III ST-A Manuel d'utilisateur Page 15