ResMed VPAP III ST-A Manuel d'utilisateur télécharger pdf (Page 38)

30

Warning Signal Cause Action

The flow generator stops

delivering air pressure.

Sound: Two alternating

continuous tones

LCD: LCD turns off

LED: Red flashing

Alarm: Power fail

• Power failure.

• Power cord is

disconnected or

VPAP III ST-A

switched off while

delivering

treatment (without

pressing the Start/

Stop key).

Alarm will stop:

when the Alarm Mute key is pressed,

or

after 2 minutes,

or

when power is restored.

The flow generator stops

delivering air pressure.

Sound: Single

intermittent tone

LCD: CHECK TUBE

LED: Yel l ow fl a s hin g

Alarm: System fault

• Air tubing

disconnected from

the HumidAire 2i/

2iC.

• Hardware failure.

1. Check that the air tubing is

connected properly to the

HumidAire 2i/2iC.

2. Check that the HumidAire 2i/2iC or

front cover is connected properly to

the flow generator.

3. Turn the VPAP III ST-A off and on

again at the power switch.

If the alarm persists, return the unit to

ResMed for servicing.

The flow generator stops

delivering air pressure.

Sound: Single

intermittent tone

LCD: PRESSURE ERROR!

LED: Yel l ow fl a s hin g

Alarm: Over pressure

Treatment pressure

delivered above a set

level.

• Return the VPAP III ST-A for

servicing.

• DO NOT USE THE VPAP III ST-A

DEVICE.

Sound: Single

intermittent tone

LCD: IPAP LOWER

ALARM

LED: Yel l ow fl a s hin g

Alarm: Over use

VPAP III ST-A is

operating outside

device specifications.

Continue using and contact your

clinician about this alarm. Device

settings may require adjustment.

The flow generator stops

delivering air pressure.

Sound: Single

intermittent tone

LCD: SENSOR ERROR!

LED: Yel l ow fl a s hin g

Alarm: System Error

Hardware error. • Return the VPAP III ST-A for

servicing.

• DO NOT USE THE VPAP III ST-A

DEVICE.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Commentaires sur ces manuels

Pas de commentaire