ResMed VPAP III ST-A Manuel d'utilisateur télécharger pdf (Page 37)

29The Alarms

The Alarms

The VPAP III ST-A unit is fitted with alarms to alert you to changes that will affect

your treatment.

Alarm Mute Key

You can mute an alarm by pressing the Alarm Mute key once. If the problem is

still present, the alarm will sound again after two minutes. An alarm LED will

remain lit for as long as the problem is present.

Testing the Alarm

To test the alarm, hold down the Alarm Mute key for three seconds. On release

of the Alarm Mute key, the alarm should sound and the LED should flash for 10

seconds and then stop. ResMed recommends testing the alarm each week.

All menus remain available during an alarm. Treatment screens are not viewable

during an alarm condition.

Alarms Troubleshooting

The most common reason for an alarm to sound is because the system has not

been properly assembled. Check that the air tubing has been properly attached

to the flow generator and mask (and humidifier if used).

When an alarm has been activated, the bottom line of the LCD screen will display

either alarm information or recommended instructions for you or your clinician.

Note: The alarm actions listed below are based on having the appropriate alarm

settings for your therapy. When an alarm is activated, confirm the alarm

settings with your clinician.

CAUTION

In the event of power failure or machine malfunction, remove the mask.

Alarm LEDs

Alarm Mute key

LCD screen

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Pas de commentaire

ResMed VPAP III ST-A Manuel d'utilisateur Page 37